CRL FP1 Finger Pull Machine

• Depth Screw Adjustment Assures Each Groove Will be Exactly Alike
• Built-In Water Tank for Maximum Portability and Dust Elimination
• Fully Adjustable Counterweight Allows User to Change the Rate of Cut

The CRL FP1 Finger Pull Machine is the fastest and easiest way to grind a 5/8 inch (15.9 mm) wide long finger groove in glass. These grooves are actually recessed into the glass to act as handles in sliding glass windows and glass furniture doors. The most common examples would be in showcases in reception areas; two places where the constant opening and closing of sliding windows is needed, but typical handles are not used or desired. The FP1 is precision built. The entire body is welded steel and finished with an enamel paint. Sealed bearings are used throughout the machine to ensure long life from all of the drive components. All parts are carefully machined and balanced to ensure smooth, quiet operation.
CRL's FP1 is powered by a 1/2 HP, 1,725 R.P.M., 115/230 Volt, Single Phase, 60Hz TEFC motor. The unit comes pre-wired with a steel switch and a heavy duty 8-foot power cord with grounded plug. The replaceable abrasive wheel measures 14 x 5/8 inch (355 x 15.9 mm) thick with a 3/4 inch (19 mm) diameter bore. At 47 pounds (21.32 kg) total weight, the CRL FP1 is portable right to the job-site. A rugged all-around machine designed for years of service. One year manufacturer's warranty covers all major components.