POWR BOND Hi-Viscosity Auto Glass Urethane Adhesive - 10.1 Fl. Oz. Cartridge

Roll over image to zoom in

CRL 1217349 POWR BOND Hi-Viscosity Auto Glass Urethane Adhesive - 10.1 Fl. Oz. Cartridge

Item #: 1217349 by Somaca

Item Discontinued!
16 16 reviews
The item is currently out of stock and it may or may not be restocked
OUT OF STOCK

Shop with Confidence

30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.

  • Easy Gunning
  • Meets or Exceeds U.S. Federal Motor Vehicle Safety Standards 208 and 212
  • Screw-On V-Cut Nozzles
  • Value Priced, Fast Curing, Cold Applied
  • Part of the LYNX Services Program

Contents

10.5 Fl. Oz. (310 ml)

Lynx Test

Click Here

Shelf Life

12 Months

Color

Black

CRL POWR BOND Hi-Viscosity Urethane Adhesive is a fast curing adhesive that passes or exceeds U.S. Federal Motor Vehicle Safety Standards FMVSS212 (Barrier Crash Test) and FMVSS208 (Occupant Crash Protection) in its most severe interpretation with dual air bags and unrestrained dummies. The fast curing formula is tack free in only 50 ±10 minutes and offers Safe Drive Away Time in as little as 1-1/2 hours when used on vehicles without a passenger side air bag, 3 hours with passenger air bag at 73°F (23°C) and 45% RH (relative humidity).
Cleaning and Primers: CRL Urethanes are supported by a one-step primer and aerosol cleaner formulated for use in all aspects of glass bonding, including the glass frit, pinchweld, and EPDM/PVC moldings.
1. After removing all of the old urethane to within 1/16" (1.5 mm) of the pinchweld, prepare the pinchweld following the procedures outlined in the CRL Technicians Training Manual. Prime these areas with 1214006 One Step Primer.
2. Clean the inside of the windshield with a lint-free towel 1550 and PWR22 Automotive Glass Cleaner.
3. Apply the same 1214006 One Step Primer to the frit area with a lint-free towel and allow to dry for a minimum of 10 minutes, but no more than 8 hours before installing the adhesive. This procedure must be performed above 40°F (4°C). NOTE: One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage.
4. Apply 1214006 One Step Primer to encapsulated moldings if they are part of the bonding area.
Packaged in metal cartridges with 4-1/2" (114 mm) long screw-on Cone Nozzles included in every case. 12 cartridges per case. Important Notes: For use by trained applicators only. Please refer to CRL Technician Training Manual, Technical Spec Data Sheet and Material Safety Data Sheet before using product. Cat. No. 1214006 One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage. Store cartridges closed and upright when not in use. Store between 65°F (18°C) and 75°F (24°C) in dry conditions. IMPORTANT: CRL9P and CRL9GC Primers cannot be used with PWR Bond 1217349 Urethane. Must use Cat. No. 1214006 One Step Primer.