CRL 2604 1/4" Prismatic Glass Drill

Item #: 2604 by CR Laurence

1 reviews

In Stock $46.55 /each

SAVE UP TO 4.65

Buying in bulk

Roll over image to zoom in

CRL 2604 1/4" Prismatic Glass Drill

Item #: 2604 by CR Laurence

1 1 reviews

In Stock $46.55 /each

SAVE UP TO 4.65

Buying in bulk

QUICK SHIPPING*Usually ships in 1 business day
QTY
+
+ Add to Wishlist
Buy in Bulk & Save - See How Watch Now

Shop with Confidence

30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.

  • Available Sizes from 1/8" to 1/2" (3.2 to 12.7 mm)
  • Our Best Carbide Drill
  • Precision Ground on Three Sides

Recommended RPM

500 - 600

Shank Diameter

1/4

Drill Diameter

1/4" (6.4 mm)

Material

Carbide

Drill Bit Size

1/4

Shank Type

Reduced Round

Speed (rpm)

500-600

Works On

CRL2 And SDM4


This CRL Prismatic Glass Drill is the standard of quality for glass drilling throughout the flat glass industry. The tungsten carbide tips mean you can produce hundreds of high quality holes without needing to re-sharpen the drill. The extra long tip assures long lasting, precision drilling.
Prismatic Drills should only be used in glass drilling machines such as the CRL2, SDM4, and 41, or in a securely held electric drill. We do not recommend you use them with hand brace drills. Be sure to keep the drill cool using CRL Cat. No. PGT1 Pure Gum Turpentine or another coolant, such as CRL DTC80 during drilling.NOTE: Always wear the proper safety gear, including gloves and eye protection, when drilling glass. Work should be performed on a flat, horizontal surface. A Ground Fault Circuit Interrupter, such as CRL Cat. No. GF1, must be used when using any type of electric tool in conjunction with water or coolant. Failure to follow any of these precautions can result in operator injury.
Product Warning:
These drills should be run at 400-600 RPM to achieve maximum drilling performance. The tip of the CRL Prismatic Drill is not ground to a sharp point. There is a slight angle at the tip to allow the drill to first scratch the glass and begin the drilling of the hole.

Most shipping weights are approximate and have not been verified. If the exact weight is needed in order to determine shipping costs, and shipping costs are required in order for you to complete your order, please request this prior to submitting your order by contacting CRL Customer Service. Product images shown are of the actual product or a close representation. Colors can vary depending on your computer's video card and on how your monitor's color is adjusted.