Brushed Stainless Laguna Series Full Height Vertical Rod Insert

Roll over image to zoom in

CRL LS7BS Brushed Stainless Laguna Series Full Height Vertical Rod Insert

Item #: LS7BS by CR Laurence

Item Discontinued!
See reviews See reviews
The item is currently out of stock and it may or may not be restocked

Shop with Confidence

30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.

  • Full 76-1/4" (1.9 m) Long Rod
  • Use with Cat. No. LS8BS Pivots

Outside Diameter

1" (25.4 mm)


.083" (2.1 mm)


76-1/4" (1.94 m)


Full Height Vertical Rod Insert


Brushed Stainless


Brushed Stainless Steel

This CRL Full Height Vertical Rod Insert is used with Cat. No. LS8BS Top and Bottom Pivot Rods to create a full height vertical pivot rod. Rod length is 76-1/4" (1.94 m), outside diameter is 1" (25.4 mm), with a wall thickness is .083" (2.1 mm).
NOTE: The following guidelines are to be used when making a door using this hardware:
Maximum Height: 98-1/2" (2500 mm)
Maximum Weight: 176 Lbs. (80 kg)
Maximum Width: 47-1/4" (1200 mm)
If the door exceeds any of these limitations, full door rails should be used.


Stainless Steel Advisory: Although Stainless Steel is resistant to corrosion, it is not rust or stain proof. CRL recommends periodic maintenance to help maintain its factory finish. For more information, view the Stainless Steel Disclaimer found in the Technical References section below.