Dow DOWAGCMB5GClick To Copy DOWSIL ALLGUARD Silicone Elastomeric Coating Mid Tint Base - 5 Gallon Pail

DOWSIL AllGuard Silicone Elastomeric Coating is a one-part, 100 percent water-based silicone elastomer supplied in three tint bases for pigmenting at distributor locations. The coating is typically applied in two coats. The use of DOWSIL AllGuard Primer may be necessary based on the substrate. The coating can be roller, brush, or spray applied. It cures to form a flexible membrane that is impervious to water but has the ability to "breathe," allowing water vapor to escape from inside the substrate. Its matte finish minimizes brush and roller marks. The coating provides long-term waterproofing protection, withstanding hurricane-force, wind-driven rain; normal movement imposed by seasonal thermal contraction and expansion; ultraviolet radiation; and the elements. The coating maintains its water protection properties even when exposed to sunlight, rain, snow, or temperature extremes. Once pigmented, it is a ready-to-use material that can be applied between -6 degreeC (20 degreeF) and 38 degreeC (100 degreeF) to a clean, dry surface. The average drying time is 4 to 8 hours, depending upon temperature, humidity, and wind conditions. If the temperature drops below -6 degreeC (20 degreeF) after the coating is applied, the average drying time will increase. DOWSIL AllGuard Elastomeric Coating requires temperatures higher than -6 degreeC (20 degreeF) for a cumulative total of 24 hours to dry. Applicable Standards: ASTM C711, ASTM D412, ASTM D522, ASTM D1475, ASTM D1653, ASTM D1849, ASTM D2196, ASTM D2240, ASTM D2243, ASTM D2369, ASTM D2697, ASTM D3274, ASTM D6904