Lonsdor KH100+ Functions: Once registration/activation has been completed the programmer will enter the menu interface: Identify Copy Enter this submenu and follow the system prompts to identify the remote. Access Card Cloning Using this submenu you'll be able to identify and copy IC cards as well as garage keys. Simulate Chip Point the device's antenna towards the ignition switch as shown choose the corresponding chip type to simulate. The device supports the following chip types: 4D / 46 / 47 / 48 Generate Chip Place the desired chip into the induction slot (as shown), then choose the corresponding chip you wish to operate according to the prompts. Note: some chip data will be covered and locked Generate Remote Within the Generate Key menu select ->[Generate remote], then choose the corresponding vehicle type to generate remote control(as shown) according to different regions. Generate Smart Key Within the Generate Key menu select ->[Generate smart key], then choose the corresponding vehicle type to generate smart key/card(as shown) according to different regions. Identify Coil Search smart induction area Connect remote key with remote connector, Put KH100+'s antenna close to the pre-determined position. If an inductive signal is identified, the device will continuously make sounds, please check if the position is right(as shown below). Detect IMMO Connect remote key with remote connector, Put KH100+'s antenna close to key identification coil, and use the key to turn ignition ON. When the KH100+ buzzer beeps, it means the signal is detected. Remote Frequency Enter this menu and then point the remote towards the device's induction area to detect remote frequency.