SPS S90120M Mill Standard Overhead Track - 120"

Item #: S90120M by CR Laurence

See reviews

$576.36 /each

SAVE UP TO 57.64

Buying in bulk

Roll over image to zoom in

SPS S90120M Mill Standard Overhead Track - 120"

Item #: S90120M by CR Laurence

See reviews See reviews

$576.36 /each

SAVE UP TO 57.64

Buying in bulk

Special Order*

Usually ships in 1-2 weeks

QTY
+
+ Add to Wishlist

Shop with Confidence

30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.

  • Available in Mill Aluminum or White Powder Paint Finishes (Cladding on Special Order)
  • Available in Two Stock Lengths 120" (3.05 m) and 240" (6.10 m), Plus Splices for Roller Access
  • Fabricated Corners and Intersections
  • Standard Track – for Almost Any Installation
  • Track is Pre-Drilled for 3/8" (10 mm) Fasteners at 24" (610 mm) Center-to-Center Spacing

Length

120" (3.05 m)

Finish

Mill

CRL SPS Overhead Track and Access Splices are 6063-T6 Alloy Aluminum, and are designed to accommodate the heavier loads required in stacking system installations. Two configurations, three lengths, and two finishes are carried in stock for immediate shipment. Lengths requiring cladding require 5 to 7 working days to fabricate. All lengths are pre-drilled at 24" (610 mm) on center for 3/8" (10 mm) fasteners. Contact our Technical Sales Department for additional information. Important Notes: STRUCTURAL DISCLAIMER - All customers who in any way utilize this product are solely responsible to consult a structural engineer to determine the suitability of the product for the intended use and site conditions. All installers must be qualified and have professional knowledge about compliance with local, state and federal regulations, safety factors, and the appropriate choice of fixing material and procedures. Each Splice is provided with four each 12" (305 mm) sliding keys to aid in aligning and securing the splice in place, and to allow for future roller removal if necessary. Splices should be located in front of the first parking intersection.