CRL SR10S0RB3812CL Oil Rubbed Bronze 10" Custom Length Square Sidelite Rail for 3/8" or 1/2" Glass

Item #: SR10S0RB3812CL by CR Laurence

See reviews

Roll over image to zoom in

CRL SR10S0RB3812CL Oil Rubbed Bronze 10" Custom Length Square Sidelite Rail for 3/8" or 1/2" Glass

Item #: SR10S0RB3812CL by CR Laurence

See reviews See reviews

Shop with Confidence

30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.

  • Reversible Extruded Saddle to Match 1/4" or 3/4" (6 or 19 mm) Door Clearances
  • Provides Even Sightline With Our Door Rails
  • Vinyl Provided to Use with 1/2" (12 mm) Glass; Vinyl for 3/8" (10 mm) Glass Ordered Separately
  • Ready-to-Ship Models From CRL Inventory
  • Use Monolithic Tempered Glass
  • Matching Door Rails Available for an Even Sightline

Minimum Order

1 Each

Length

Custom

Finish

Oil Rubbed Bronze

The CRL 10" (254 mm) Square Sidelite Rail is commonly used in office and storefront applications to secure fixed glass panels. Since the profile matches our Door Rails, these Sidelite Rails can be used top and bottom for a matching look, or with a variety of smaller configuration U-Channels. Glass is installed easily with the 'lift and drop' method using our 4" (102 mm) Aluminum and Neoprene Setting Blocks. Glass is secured with a Top Load EPDM Roll-in Glazing Gasket that eliminates the messy application of silicone sealant.
ORDERING INFORMATION:
• Sidelite Rails on this page come with vinyl to glaze 1/2" (12 mm) glass. If using 3/8" (10 mm) glass, GG38 Series Vinyl must be ordered separately.
• All models are available in 120" (3.05 m) lengths. Selected finishes are also offered in 240" (6.10 m) lengths.
• Custom lengths and finishes are also available.
• SREC10S Series End Caps and Cat. No. UCSB4 Setting Blocks must be ordered separately. Important Notes: Products manufactured by C.R. Laurence Co., Inc. (CRL) with an Oil Rubbed Bronze Finish are inspected at our facilities prior to packaging and shipping. Within two days of receipt of these products you are advised to open the package, remove all of the protective wrap from the product, then inspect the product thoroughly. You must report any damage or irregularity of the finish to CRL immediately. Please be advised that CRL will not be held liable for damages reported at a later date. Shown with End Caps which must be ordered separately. Stainless Steel Cladded Aluminum and cannot be cut with a standard chop saw or abrasive blade. These will cause the Cladding to heat up and burn the finish. This material must be cut with a cold saw to prevent damage to the finish. For further information please contact Technical Sales.