Power Probe Diagnostic Tools PPFUSECBINTClick To Copy Power Probe PPFUSE Fuse Monitor

The Fuse Monitor from Power Probe is the newest tool in our Parasitic Draw diagnosis lineup. The Fuse Monitor is used to locate / isolate where your parasitic draw lies by measuring current across fuses on the vehicle without removing them. The Fuse Monitor can be used on Maxi, Mini, & ATC fuses alike with a maximum Amp rating of 80A. Quickly locate parasitic draw by probing each fuse on the fuse panel while watching the top of the tool that displays inactive (green) active (yellow) or open (red) in each condition, if you see green move on, and do so until you see an active or open circuit. Use the Draw Monitor from Power Probe to quantify the amount of parasitic draw on the vehicle (Current flow during the sleep condition) and then use the Fuse Monitor to figure out what fuses are flowing current when they're supposed to be asleep. Typically this is done by using a a multimeter in voltage mode where you'll then refer to fuse charts to convert voltage drop to current but no more are the days where you have to carry around conversion charts... The Fuse Monitor reads out current flow on fuses in real time so that you can find all the current that your draw monitor displays. Gone are the days where you could pull fuses one by one to find your draw because todays vehicles have modules that wake up when you pull the fuse, so in order to not reset the process current flow must be read while the fuse is installed. This tool is USB-C rechargable, comes with a belt clip, has replaceable tips, and much more. For all your parasitic draw needs, look no further than the Fuse Monitor from Power Probe.