Certainly! Highside Chemicals 31057 Epoxy Just for Copper High Strength is designed specifically for bonding copper, brass, and bronze. Here are the steps to use it effectively: Prepare the Surface: Ensure that the copper surface is clean, dry, and free from any contaminants or residues. Roughen the surface slightly using sandpaper to improve adhesion. Mix the Epoxy: This epoxy comes in a 2 oz tube blister pack. Squeeze out an appropriate amount of epoxy onto a clean surface. Mix the epoxy thoroughly by hand. It has a 10-minute working time before it starts to set. Apply the Epoxy: Use an applicator tip or a small brush to apply the epoxy to the copper surface. Make sure to cover the entire bonding area evenly. Bonding and Curing: The epoxy will start to set within 15 minutes. It reaches 90% cure in approximately 4 hours. For full cure, allow 24 hours. Temperature Range: The epoxy can withstand continuous temperatures up to 260°C (500°F). Strength Properties: Tensile Strength: Over 1000 psi (ability to pull pipe from fitting). Rotating Strength: 350 psi (ability to twist pipe from fitting). Compression Strength: 18,000 psi. Hardness: Shore D 85. Remember to follow safety precautions and manufacturer guidelines while using this epoxy. It’s a reliable choice for copper bonding applications!