Tie Down Engineering 26411Click To Copy I) 3" O.D. Pipe Holder Silver

Build your own dock with this hardware and the lumber you purchase separately. We offer a complete line of rugged dock hardware for building a dock at your summer cabin or waterfront home. Designed primarily for non-commercial users, it's sturdy enough for boatyards and smaller marinas. Commercial Grade (1/4") Tie Down Dock Hardware is designed for use with 1-1/2" thick lumber (sold separately, minimum width 6"). All hardware is mounted with 3/8" carriage bolts. All male and female dock to dock connections are made with either 3/4" bolts with lock nuts or 3/4" connecting pins. Tie Down's Wood Dock Planning Kit will show you the basics of building a lightweight and long lasting floating dock system. Useful Resources To help get you started, we offer a Planning Kit that's filled with details about dock design and construction. Once you have a plan and materials list, we'll supply the hardware andyour local lumber yard can provide the wood. List of Components A. Inside Corner: Used in combination with Outside Corner (E) to connect side and cross stringers on end of dock section. Includes welded gusset for dock framing. Requires eight 3/8" carriage bolt sets. 8 1/4"L x 5"H with 2 1/4" elongated holes. H. Washer Plate: Used with cross stringers to back up Angle Braces (C) or Pipe Holders (I). Two carriage bolt holes. 1 1/2"L x 5"H. Four 9/16" holes om 3 1/2" centers. B. Backup Plates: 5" x 5" reinforcing plates are used to back up the Single T Males (F) and Females (G). Four 9/16" holes on 31/2" centers. C. Galvanized Stringer Angle: Used to attach cross stringers to side stringers, and is backed up by Washer Plates (H). Requires four 3/8" carriage bolt sets. 2 3/4"W x 5"H. Four 9/16" holes om 3 1/2" centers. J. Outside Corner, Female This is identical to the Outside Corner End, except it has two 1/2" tabs which connect to a Male Outside Corner (K) to create a flexible joint between dock sections. No additional bolts required if used with an Inside Corner. Each leg is 10"L x 5"H. D. Inside Corner with 2" Pipe Holder: This inside corner allows you to use pipe at each corner for anchoring. Dock will float up and down if water level changes. Used in combination with outside corners (E). Requires eight 3/8" carriage-bolt sets. 8 1/2"L x 5"H. F. Single T, Male: Used to connect finger dock to main walkway, and to attach dock sections to seawalls. Single 1/2" tab connects to Female Single T (G) or female Outside Corner (J) to allow articulation. Four bolt holes. 5"L x 5"H. Four 9/16" holes on 3 1/2" centers. G. Single T, Female: Used to connect finger docks to main walkway, and to attach dock sections to sea walls. Used with Male Outside Corner (K) or Male Single T (F) to allow articulation. 5"L x 5"H. Four 9/16" holes on 3 1/2" centers.