RECENTLY VIEWED
Skip to main content
DK Hardware Professional Tax Exempt? Net 30? - DK Net Terms
Roll over image to zoom in
30 Days Easy Return. We are the largest supplier of the most adaptable, personalized hardware in the industry. We work hard to ensure you're satisfied with our products.
WARNING: This Product May Contain Chemicals Known to the State of California to Cause Cancer or Reproductive Harm. To Learn More Visit P65Warnings.ca.gov
Features
- Manufactured from brass to maintain consistent shape and accurate fit during installation
- Polished Chrome finish provides a uniform surface appearance on wall mounted glass panels
- No-drill clamp designed to secure fixed glass panels without drilled holes or notches in the glass
- Supports glazing thickness of 1/2" using clear gaskets and set screw retention.
- Two nylon tipped set screws are tightened to secure the glass panel in place
- Wall mount design includes mounting screws for wall, ceiling, or floor installation
- Requires use of silicone reinforcement along all glass edges where clamps are installed
Finish
Polished Chrome
Overall Depth
53/64" (21mm)
Mounting Type
Wall Mount
Material
Brass
Wall Thickness
1/8" (3mm)
Overall Width
1-3/16" (30mm)
Center to Center
1-3/8" (35mm)
Glass Thickness
1/2" (12mm)
Overall Height
2-3/8" (60mm)
Glass Fabrication Required
No
Included
Clear Gaskets And Mounting Screws
Glass Requirement
Monolithic Tempered Glass
Hole Center Offset From Edge
1/2" (12mm)
Product Overview
The No-Drill clamp for 1/2" glazing thickness is designed to secure fixed glass panels without drilling holes or cutting notches in the glass. It is manufactured from brass and finished in Polished Chrome providing a uniform surface appearance. This clamp is intended for wall mounting and is used with monolithic tempered glass. It supports a glazing thickness of 1/2" and does not require glass fabrication. Two nylon tipped set screws are used to tighten and hold the glass in place within the clamp. Clear gaskets are included to help cushion the glass during installation. Mounting screws are provided for wall, ceiling, or floor attachment. Silicone must be used for reinforcement along all glass edges where clamps are installed. The clamp features an overall height of 2-3/8", an overall width of 1-3/16", and an overall depth of 53/64", with an inner depth of 9/16" to accommodate the glass. Mounting hole spacing measures 1-3/8" center to center, with a hole center offset from the edge of 1/2" and a side hole offset from the front edge of 9/16" on both upper and lower positions. Installation steps are 1) Confirm glass type and thickness meet requirements, 2) Mark clamp mounting locations on the wall or floor, 3) Drill pilot holes for the mounting screws, 4) Secure the clamp base using the supplied screws, 5) Insert clear gaskets into the clamp, 6) Position the glass panel into the clamp, 7) Tighten the nylon tipped set screws evenly, 8) Apply silicone sealant along all glass edges where clamps are used, and 9) Allow sealant to cure before use.